Malaysia's Architecture, Construction and Design Directory
Right Source Centre
Key Benefits
Back
Right Product @ dRightSource.com
LOCTITE Steel Putty
LOCTITE Steel Putty : SOFT like clay, HARD like steel
LOCTITE Steel Putty
LOCTITE® Fixmaster® Steel Putty 99913 -- A steel
reinforced, two-part epoxy that cures to a metal-like finish and
can be machined, drilled, tapped or filed under typical dry
service temperatures of –29° to +107°C (–20° to +225°F).
   
LOCTITE Steel Putty
" Loctite Steel Putty :  resin ( black ) & hardener ( grey ) "
   
LOCTITE Steel Putty
" Loctite Steel Putty : after mixing the resin & hardener "
   
One  contractor was requested by his customer to repair  a chiller and found that the chiller tubes were severely corroded.

After a site visit, LOCTITE  Steel Putty was proposed to repair, rebuild, and reclaim the corroded surface. This
convenient-to-use putty can be used to replace hotwork  which may be troublesome and dangerous in some work areas.
   
Application of LOCTITE Steel Putty
After mixing the resin and hardener, according to the
recommended ratio, a soft paste-like substance was formed.
The putty was then applied onto the corroded metal surface.
   
Application of LOCTITE Steel Putty
" The tube surface was masked  with masking tape "

The Loctite Steel Putty attained full cure after 24 hours -- a
hard  composite was formed

The repair job had been successfully done, though only a
fraction of the total job scope,  it was actually compliment to
the entire project.
   
Back
Malaysia's Architecture, Construction and Design Directory
Copyright © 2009, dRightSource.com, All rights reserved
Disclaimer
Contact
Right Arrow