Photo Case Studies from Stream Tech
Our experiences over the years in providing customized services to our clients have worn us
many loyal customers. Our skills and expertise have helped solved many challenging technical
issues.to Case Studies:
Back
- Supply and Commissioning of American Turbine Pump
Supply and Commissioning of American Turbine Pump
Stream Tech was tasked by client to take delivery, install and
commission this American Turbine Pump for a steel mill. We were
able to take up the technical challenge of ensuring that the pump
was installed according to the guidelines & recommendations of
the manufacturer - ATP.
   
- Maintenance & Repair of Split Pump
Maintenance & Repair of Split Pump
Photo case study of servicing a split pump.

We were able to repair and rebuild the pump to operational
specifications as required by our client. This not only resulted in
major cost-savings but it also meant that there were no need for
new capital outlays to purchase a new pump.
   
- Complete overhaul of Washington Pump
Complete overhaul of Washington Pump
Client informed Stream Tech of problems related to their pump,
including that of low flow rate, high vibration during operations and
there as frequent bearing failures.

We were able to dismantle the whole pump unit in order to service
every aspect of the pump construction. These included a
re-balancing, the restoration of the worn-out shaft, bearing
replacements and using new packing seals. Finally, the pump
screw (for both the male and female units) were also re-balanced.

The fully serviced Washington pump is now able to function again
at its operational capacity to the satisfaction of our client.
   
- Self priming centrifugal pump servicing
Self priming centrifugal pump servicing
Client had the following problems with the pump: Flow rate has
dropped to a very unacceptable level and pump casing was
leaking.

Stream Tech Solution: We were able to restore the total pump unit
back to its required flow rate. Client did not have to replace the
whole pump at very high cost.
   
- Loop Pump service and repair
Loop Pump service and repair
The photo case-study below shows Stream Tech expertise in the
service and repair of a highly specialised pump. This pump is
mounted on a tanker (tanker pump) and is used for the unloading
of tanker fluid, in this instance it was caustic soda. Our client is
from the food processing industry.
   
- Welding & fabrication, piping & fittings
Welding & fabrication, piping & fittings
Photographs show the Stream Tech team at work on-site providing
general mechanical works (welding and fabrication, piping and
fittings). We are also able to do general mechanical works for
assembly lines.
   
- General Electrical Works
General Electrical Works
Photo case studies of Stream Tech providing general electrical
works at various plants, factories, terminals, office premises, etc.
   
- Electric Motor servicing
Electric Motor servicing
Stream Tech also services, repair and re-conditions electric
motors of various types. This photo case study shows an electric
motor at a bulking terminal being serviced, repaired and brought
back into full operating condition.
   
- Electrical Control Panels
Electrical Control Panels
Stream Tech re-designed, constructed and replace the electrical
panel for a powder mixer at a pharmaceutical factory.
   
STREAM TECH LOGO
Malaysia's Architecture, Construction and Design Directory
Copyright © 2009, dRightSource.com, All rights reserved
Disclaimer
Malaysia's Architecture, Construction and Design Directory
Right Source Centre
Key Benefits
Back
Right Product @ dRightSource.com
Contact
Right Arrow