Malaysia's Architecture, Construction and Design Directory
Right Source Centre
Key Benefits
 Back
Right Product @ dRightSource.com
SPERONI SELF-PRIMING PUMPS APM SERIES
SPERONI SELF-PRIMING PUMPS APM SERIES

Self-priming water pumps for deep suctions up to mt. 45 to be used in
case of important water level gaps. Suitable to drain water from wells
and in domestic fittings by small and medium sized tanks. Before
installing the pump verify that all pipes (iron, plastic or rubber) are clean
inside so to avoid any obstruction to the ejector nozzle. At the foot of the
ejector must be installed a foot valve or a check valve. Installed the
pump, fill completely both pipes and pump body with clean water. To
preserve an efficient priming it is necessary a certain pression in the
circuit, therefore it is recommended to install a membrane tank at the
delivery of the pump.

Operating conditions  

Liquid temperature up to 35°C Ambient temperature up to 40°C Total
suction lift up to 45 mt. Continuous duty  

Motor  

Two-Pole induction motor (n = 2850 r.p.m.) Insulation Class F Protection
IP 44  

Materials  

Pump body: Cast Iron Motor Support (AP-APM 75-100): Aluminium Motor
Support (AP- APM 150-200): Cast Iron Impeller: Noryl Diffuser: Noryl
Ejector: Cast Iron Pump flange (AP-APM 75-100): Stainless Steel Shaft
with rotor: Stainless Steel Mechanical seal: Carbon/Ceramic
 
 
YSH LOGO
 Back
DIAGRAM 1
TECHNICAL DATA
Technical Data
Malaysia's Architecture, Construction and Design Directory
Copyright © 2009, dRightSource.com, All rights reserved
Disclaimer
Contact
Right Arrow
Mention Us